Commercial Vehicle Check Equipment --> Enforcement Center:
violation notification

Definitions

violation notification (Information Flow): Notification to enforcement agency of a violation. The violation notification flow describes the statute or regulation that was violated and how it was violated (e. g., overweight on specific axle by xxx pounds or which brake was out of adjustment and how far out of adjustment it was). A violation differs from a citation because it is not adjudicated by the courts.

Commercial Vehicle Check Equipment (Source Physical Object): 'Commercial Vehicle Check Equipment' supports automated vehicle identification at mainline speeds for credential checking, roadside safety inspections, and weigh-in-motion using two-way data exchange. These capabilities include providing warnings to the commercial vehicle drivers, their fleet managers, and proper authorities of any safety problems that have been identified, accessing and examining historical safety data, and automatically deciding whether to allow the vehicle to pass or require it to stop with operator manual override. Commercial Vehicle Check Equipment also provides supplemental inspection services such as expedited brake inspections, the use of operator hand-held devices, mobile screening sites, on-board safety database access, and the enrollment of vehicles and carriers in the electronic clearance program.

Enforcement Center (Destination Physical Object): The 'Enforcement Center' represents the systems that receive reports of violations detected by various ITS facilities including individual vehicle emissions, lane violations, toll violations, CVO violations, etc.

Included In

This Information Flow is in the following Applications:

• Smart Roadside Initiative

This Information Flow is in the following Application Objects:

• CVCE Citation and Accident Electronic Recording

Communication Diagrams

The communication diagram(s) can be viewed in SVG or PNG format and the current format is SVG. Switch to SVG format. PNG format.

This profile describes applicable standards for communicating between with ITS Roadway devices using the simple network management protocol (SNMP).




This profile describes an alternative set of standards used to communicate with ITS Roadway Devices that uses the NTCIP Octet Encoding Rules (OER), a standard developed specifically for the transportation industry. This template is used primarily for communication with traffic signal controllers, where second-per-second communications is required. This template also includes standards for SNMP traps, that allows an ITS Roadway Device to initiate event-driven communications with a receiver.

Characteristics

Architectural:

Security

This information flow triple is in the following applications with the following security levels.